![]() ![]() Which way does the spare tire go on? The Versa spare tire should always be mounted with the valve stem (the thing you put air into) pointing out. The video also shows how to put the 2010 Nissan Versa back in its original location. Most Nissan jack kits include the jack, a jack handle and a lug nut wrench. This video shows you where the spare tire, jack and jack kit is located in your Versa how to assemble the components of the spare tile tool kit, how to replace the flat tire with your spare tire and safety precautions to take when using your jack. Make sure you are in a safe area that is level and free of traffic before attempting to fix a flat tire. That almost always pops through the corrosion binding the wheel to the hub.Learn how to change a flat tire using the Nissan Versa spare tire kit. Then get in, put the car in gear and let it roll just a few inch and hit the brakes hard. Lower the car, remove the lift and chocks. Worst case, put the lugs back on, almost tight but not all the way. That should pop the wheel loose of the hub. Then with a mallet, give the TIRE a good wack. Wiggle the car to make sure it is stable and secure on the stand. Proper height needs only be so the tire is an inch or so above the floor/ground. Lower the jack lift just enough to settle the weight on the stand. Jack up the corner of the car you are working on and put a jack stand in the proper place as defined by the manual. Make sure you slide them tight to the tires.īreak loose but do not remove the lugnuts. Put wheel chocks behind the tires not being lifted (rear in this case).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |